[Open-FCoE] problem while using fcgw

manali baldawa manali.baldawa at gmail.com
Thu Sep 18 07:47:21 UTC 2008


I tried exporting  this varible export FCOE_OUI=0xefc00 on gatway side and
started fcgw again...
but i am still facing problem??
can anyone help me in this??
have anyone used fcgw?? If yes , how did it work ??
Please help me out??

Manali

On Fri, Sep 12, 2008 at 3:37 PM, manali baldawa <manali.baldawa at gmail.com>wrote:

> I want to use fcgw
> I have setup *fcoe initiator  -> fcgw -> ( any fc simulator)*
> I have all hardware in place ....
> i used all configuration steps which are mentioned on open-fcoe-wiki......
> but i am not able to see luns on initiator side.
> I think either i missed out something on fcgw...
>
> i used following steps to set up fcgw.
> 1.I have 2gbps atto card
> 2. downloaded tachynet driver from sourceforge.net(link provided on wiki
> page)
> 3. modprobe tachynet
> 4. ifconfig efc01
> 5.ifconfig eth1
> 6.fcgw -i eth0 -f efc0 -n &
>   gateway is running  now
>
>
> Target setup
> i have qlogic  and i am using scst .
> luns are created on target
>
> Initiator setup
> I have new open-fcoe code
> loaded fcoe module
>
> 1.modprobe fcoe
> 2.echo eth1 > /sys/module/fcoe/create
>
> Could anyone please help me in this??
> is my setup is rite??
> am i missing any steps ??
>
> I studied this using wireshark , initiator is sending FLOGI but i think
> gatways is not responsding to it and not even forwarding to target.
>
>
> Thanks & Regards
> --
> Manali
>
>


-- 
Manali Baldawa
Senior Development Engineer
Calsoft Private Ltd
Email: manali.baldawa at calsoftinc.com



More information about the devel mailing list